7/1/2023 0 Comments Conector aquatermFinally, the panel heating and cooling elements can be installed in drywall construction, in plastered ceilings, walls or in suspended coffered ceilings and are invisible afterwards. Building owners and architects can be pleased about the flexible areas of application and the associated freedom of design: whether as a cooling ceiling in the office, as wall heating in the bathroom or as underfloor heating in a renovated old building – the possibilities are almost unlimited. The system is ideal for use with low temperature systems such as heat pumps. The radiant energy provides either pleasant heat or cooling without disturbing draughts or dust turbulence.Īquatherm black system works energy-saving thanks to perfect control technology. Depending on the requirements, the surface temperature of the elements is driven a few degrees above or below the desired room temperature. The special feature: It can be installed in the ceiling as well as in the wall and floor. Versatile, manufactured in compact register design and equipped with a future-proof technology – these are some of the essential features of the aquatherm black system. Since this part is no longer listed in the catalog it is suggested that this part no longer be ordered to eliminate confusion and difficulties on the job.Aquatherm black system is a multiple awarded surface heating and cooling system. It can only be used to make a connection to another Aquatherm pipe with the same 0115527 flange adapter. But if you are trying to connect to a 4” valve or other 4” flange adapter they will not mate up properly to the 0115527. The correct flange ring to use with this flange adapter is part number 3315730 which is actually a 6” flange ring. The 4” flange ring (part number 3315726) does not fit with this flange adapter as can be seen in the photos below.įigure 6: Two upper photos: 4″ flange ring (No. It was used to connect to the old-style Aquatherm ball valve that was discontinued a couple of years ago. It is designed to connect to an ANSI 5” pipe and flange. ![]() This flange adapter is a coupling, socket-type connector designed to fuse directly over a 4” pipe. 0115527 Fused on 4″ (125mm) pipeįigure 5: Flange adapter No. The second 4” and discontinued flange adaptor is product number 0115527.įigure 4: Flange Adapter No. All of Aquatherm flange rings are designed to fit with ASME 150-psi flange bolt patterns.įigure 3: Drawing and Dimensions of 4″ Flange Adapter If the opposite valve or ring to which you are connecting only has four holes, the eight-hole ring will still work and function well. This allows for the connection to another flange ring of similar configuration or to a ball or butterfly valve. 3315726.Īlso notice that the flange ring has eight holes. This allows connection to a ball valve, a butterfly valve or another flange.įigure 2: 4″ Flange Adapter No. As can be seen in the photo the 4” flange ring (part number 3315726) fits nicely over the adapter and up to the flange adapter neck. This flange adapter has an elongated neck to allow fusing a coupling socket-type connector (part number 0115526) on the end of it to continue the pipe line. The flange adapter that we will focus on first is product number 0115526. 0115527 was mistakenly ordered.įigure 1: Flange Adapter No. However, there are still inquiries, orders and subsequent problems that have arisen because the No. 0115527 and it does not appear in the new 2014 catalog. Aquatherm has since discontinued offering the No. ![]() The purpose of this technical bulletin is to help distinguish between the two products in order to help eliminate confusion and ease concerns when ordering. In the past Aquatherm offered two different flange adapters for 4” inch pipe.
0 Comments
Leave a Reply. |